Does Walmart Sell Propellers?
Posted: Tue May 28, 2013 8:40 pm
Well, I am realizing that the learning curve is going to be a lot tougher than I imagined.
I've been trying to figure out the proper sequence of events to get airborne, and have only been able to get up in the air about 3 times, and I'm beginning to think that it was only by coincidence. Most of the time I just seem to be on idle or crawling at best. I went through 9 sets of propellers this evening, and decided to pack it in before the hangar became bare.
Part of the problem turned out to be that the mouse was controlling events instead of my joystick, and I couldn't figure out how that could happen. Then it seemed that the problem was solved, but I still couldn't get liftoff tonight for some reason. I chopped down a ton of trees, but that was the extent of my accomplishments.
My career as a Dambuster looks as if it will end before it begins if I can't get off the runway.
Can someone provide me with a sequence that I should be following, as well as a control set-up template if that is required?
If this continues, I'll put away my Saitek and trade it in for a ground unit...at least I am familiar with that surface
I've been trying to figure out the proper sequence of events to get airborne, and have only been able to get up in the air about 3 times, and I'm beginning to think that it was only by coincidence. Most of the time I just seem to be on idle or crawling at best. I went through 9 sets of propellers this evening, and decided to pack it in before the hangar became bare.
Part of the problem turned out to be that the mouse was controlling events instead of my joystick, and I couldn't figure out how that could happen. Then it seemed that the problem was solved, but I still couldn't get liftoff tonight for some reason. I chopped down a ton of trees, but that was the extent of my accomplishments.
My career as a Dambuster looks as if it will end before it begins if I can't get off the runway.
Can someone provide me with a sequence that I should be following, as well as a control set-up template if that is required?
If this continues, I'll put away my Saitek and trade it in for a ground unit...at least I am familiar with that surface